Its getting there, wiring, power steering and drivetrain is all connected. Windshield is going in thursday and there is a lot of little stuff for me to do.




Valve cover as well as a lot of small brackets are off getting painted.

Looks like that thing is going to be a blast in Omaha!

I won't be able to go to the convention any more, one of my good buddies decided to get married that weekend.

I've been lazy lately but here is a little update. My windshield is on backorder so I won't have it until the end of this month which sucks.

Sprayed my rotors with high temp caliper paint so they don't look like crap from rusting anymore.


Aluminum 11ga battery tray I made for the car. Not the best welds tig welding but i'm getting there.






Also made a aluminum plate for my fuel cell to take the place of the washers holding the unit down. They weren't doing a good jop of sealing it evenly.


Gauges are mounted with the cage pods. Just have to figure out what to do with the wires to make it look cleaner.

SICK!!!!!! I must see this sometime!

you could paint a small piece of metal electrical conduit that clamps to your cage in a similar fashion as your gauges. drill a couple holes in the conduit and a few rubber grommets later, you can have some clean wiring that gets plumbed to wherever you put it. Similar to wiring a bike frame but not using the roll cage to do so.

It took awhile but I managed to find a actual carbon fiber rear view mirror. Found it on ebay and looks like it was specially made.

Nice. LOL that bracket looks like it weighs more than the mirror itself.

Looks good, man!

Any chance I could get you to make me a battery tray like that for my lil battery? Nothing fancy, I just want to be able to put a couple bolts through it to mount to the factory bolt holes. I'd throw you some loot.

shoot me a pm with the measurements of the bottom of your battery you need it for.

I've been up to a little lately.

Rear view mirror is now mounted.




Painted some stuff gun metal gray.




Mounted some of my gadgets with the help of some carbon fiber chunks I had laying around.






Reworking my exhaust a bit. This will now take place of the 02 housing and it branches to my exhaust cutout. Not the pretiest and still needs to be finished but it will be heat wraped yet to help keep temperatures down.


Did some misc things as well but its starting to get there. Shooting for this coming sunday to have it on the road.

O2 housing is done & should flow a lot better.





Installed





3" Turn down for off of the exhaust cutout







Wrie loomed the gauge pod wires.



Intercooler is now in as well as cusco strut bar



Intercooler tank, pump and heat exchanger are in





Finished up everything underneath the passenger side of the dash so the seat could go back in.





Battery tray & battery are mounted

Went for a small cruise today, deffinantly have to get use to the car again and the power steering is fucking awesome.










Aluminum coolant overflow tank


I shortened the factory throttle cable and reran it behind the engine




I've also been told I shoot some wicked flames from the cutout lol

That water to air is bad ass! I am thinking about going that route. Glad you got it back on the road!!

Looks great, man! Needs some Nissan logos on it so you're properly representin!